Blade 200 SR X RTF Manuel d'instructions télécharger pdf (Page 14)

Exploded View

Problem Possible Cause Solution

Drift in calm winds

Vibration, damaged linkage, dam-

aged servo

Under normal operation the transmitter trims should not

require adjustment and the center positions are memorized

during initialization. If you ﬁ nd that trim adjustments are nec-

essary after take off, verify the balance of all rotating compo-

nents, ensure the linkages are not damaged and make sure

the servos are in proper working condition.

Drift in wind Normal

The model will drift with the wind but should remain level in

ﬂ ight. Simply hold the cyclic stick in the necessary position

to keep the model stationary. The model must lean into the

wind to remain stationary, if the model remains level then it

will drift with the wind.

Panic Recovery or Return to

Level does not level the model

Model was not initialized on a level

still surface

Re-initialize the model on a level and still surface.

Model was not taken off of a level

surface

Always lift off from a level surface.

Severe vibration Rotating component out of balance

Check the main shaft, tail rotor, main rotor blades, main

frame and adapter for damage, replace as necessary. Vibra-

tion must be minimized for Panic Recovery and Return to

Level functions to work properly.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Blade 200 SR X RTF Manuel d'instructions Page 14