Blade Nano QX FPV BNF Manuel d'instructions télécharger pdf (Page 8)

1. Lower the throttle and throttle trim to the lowest settings.

2. Power on the transmitter.

3. Install the battery by sliding it into the battery mounting slot below the 4-in-1 control unit. Slide the battery into the

slots with the label facing downward so that the battery key, molded into the battery end-cap, comes in contact with

the key on the battery slot.

4. Connect the battery cable to the 4-in-1 control unit, matching the red mark on the battery to the red mark on the

connector.

5. Place the nano QX on its skids on a ﬂ at surface and leave the aircraft still until the LED on the 4-in-1 control unit is

solid blue (not blinking).

CAUTION: Always disconnect the Li-Po battery from the aircraft when not ﬂ ying to avoid over-discharging the

battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,

resulting in loss of performance and potential ﬁ re when batteries are charged.

Installing the Flight Battery

th b tt i t

12 3

3. Always disconnect the ﬂ ight battery from the charger immediately upon completion of charging.

CAUTION: Only use chargers speciﬁ cally designed to charge the included Li-Po battery. Failure to do so could

result in ﬁ re, causing injury or property damage.

CAUTION: Never exceed the recommended charge rate.

LED Indications

When you make the connection successfully, the LED on the charger turns solid red, indicating charging has begun. Charging

a fully discharged (not over-discharged) 150mAh battery takes approximately 30–40 minutes. The light goes out when the

charge is complete.

Solid Red: Charging

OFF: Max Charge

CAUTION: Once charging is complete, immediately remove the battery. Never leave a battery connected to the charger.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 28 29

Pas de commentaire

Blade Nano QX FPV BNF Manuel d'instructions Page 8